so a year after my bp swap i finally found a tranny(cheap one) so i need some info on it
but kinda unsure about what the jack shaft is
is this it
so if thats it i'll need that bracket, jack shaft, both axles, slave cyl and tranny mount(under battery)
for those who have done the swap did u replace all of the seals and stuff the shop manual tell you to do
thanks

 

come on someone

 

jack shaft? do you mean half shaft?

and what car are you putting this in. the DX and LX have different master cylinders. but that is more for brakes. and i woun't bother swapping them out.

to swap in a tranny,you will need the braket for the 1/2 shaft, the 2 axles, the flywheel, and ofcourse the tranny. usually the slave cyl is attached to the tranny.

yes the 1/2 shaft is the shaft behind the block with the green thing attached.

Note* that green end is part of an old axle.

 

i know what i need for the swap i just wanted to know if that was the jack, half, joint - shaft for sure
thanks