I got a new best on the dyno. 125whp and 116lb-ft of torque. I'm pretty happy about that. I was finally able to tune my intake cam properly, and everything worked out well. Those are pretty good numbers considering I've got such few mods. Proper tuning is the key. Can't wait to get that custom header done....

 

fkn a man awsome!!!!!!!!!!!!!!!!!!!!!!!! are u runing sohc?

 

I'm not sure one could EVER get 125whp from a SOHC without forced induction. It's definitely a DOHC.

 

Ah ok, are u sure no on could ever get 125 sohc? Because i dynoed at 107@ 6300 rpm whp and 110@ 5500 lb-ft , my mods are custome air intake and 93 octain gas, ill post the sheets

 

If you spent enough money, you could make 200whp out of that engine. BPs baseline 105-110, so there's no way an SOHC is getting 107 with just intake. No offense. I'm assuming that was on a Mustang dyno?

 

no ur right on an intake it wouldnt get the power to the wheel! I faild to mintion that i have a act stage 2 clutch/pressure plat in it my bad