I am having a problem fitting the 2 red sleeves over the MAF sensor and the sleeves dont seem to fit over the piping either, can somebody please give me some answers fast?

Thank You,
David

 

try to use some WD 40

 

I had the same problem. actually it does fit. Loosen the clamps as far as they will go and then you ll have to wedge it over the MAF sensor. IT WILL FIT. Do it on a warm day. Do not use WD 40, the seal will always be loose and attract tons of dust.

The second this is dont push it all the way up the MAF tube, it actually sits about half a cm from it, then youll be able to get the clamps over it.....dont give up!!!

 

Here are some picts, I hope this helps:

http://www.edmontonprotegeclub.com/f...=ST&f=9&t=103:)

 

oop. use this one
http://www.edmontonprotegeclub.com/f...t=ST&f=9&t=103

 

I tryed it and they still do not fit what so ever so i sent the 2 sleeves off to injen and they are supposed to be sending me 2 more that will fit.

Thanx anyway,
David

and the pic didnt work, try it again to let me see if it is what im talking about, cause the sleeve would not fit at all.