intake problem
September-27th-2003 | 01:44 PM
#1
Thread Starter
Registered User
Joined: Sep 2003
Posts: 333
From: Chico & bayarea cali
intake problem
I have a 00 1.6L protege. I recently installed an intake for the 1.8L that i bought from ebay. I modify it by drilling a bigger hole for the MAF and sealed it with silicon. There are no leaks. But the car starts and dies, i'm assuming the car is getting too much air. i'm using 3" in piping. Any info that can help. thanks
September-30th-2003 | 04:33 PM
#2
Registered User
Joined: Jul 2002
Posts: 19
From: Madtown, Midwest, US
Re: intake problem
Originally posted by jster28
I have a 00 1.6L protege. I recently installed an intake for the 1.8L.... I'm using 3" in piping.
I have a 00 1.6L protege. I recently installed an intake for the 1.8L.... I'm using 3" in piping.
You're using 3" diameter piping
OR
extra 3" of piping were used in order to fit the 1.8's intake to your 1.6?
September-30th-2003 | 05:02 PM
#3
Moderator/ Pocket Tuner
Joined: Apr 2002
Posts: 4,150
From: Tampa,Fl
check how you maf is mounted inside the piping...most likely it is mounted with the airlow in the wrong direction, or your seal isnt good..glopping silicone around it isnt good enough...best bet is to get a bicycle inner tube and make a gasket....also make sure the MAF is clean..if not you need to get some alcohol and a cotton swap and be VERY careful and clean it up....it isnt the size of the tubing, trust me!!!
Thread
Thread Starter
Forum
Replies
Last Post
P5RUNNER
3rd gen Engine/Drivetrain
3
January-31st-2003 02:25 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)