Still Stuttering - F$%K!!!
#1
Still Stuttering - F$%K!!!
I took my valve cover off to clean it. Then put it back using the same gasket cover. Major Mistake! Oil drained out, especially in plug #1. Car is now stuttering bad and occasionally stalling in first. I bought a gasket kit from Mazda and sealed it right, no leakage now. Still stuttering in 1st and 2nd though. Hooked up the car to a diagnostic machine which told me plug #1 is misfiring. Changed the plugs and cleaned out all the oil. Still doing the same ****. Change the plug wires next? Any Ideas?
#5
sorry chastan....
I read your post literally. If you think the sig is funny hit the link to go to their website. http://www.stuntaz.cjb.net/ The Three Stooges.
This thread is getting sidetracked, sorry.....Bump for mechanical help
This thread is getting sidetracked, sorry.....Bump for mechanical help
Last edited by Witchdoktor; January-25th-2003 at 08:51 PM.
#7
Originally posted by shumax
Sounds like you need to get the oil out of the plug wire. Use an air compressor and blow it out.
Curt B. Shumaker
Sounds like you need to get the oil out of the plug wire. Use an air compressor and blow it out.
Curt B. Shumaker
#8
You can also use a bicycle tire pump and shoot air down into the plug wire's hole. At the very worst you might have to buy new wires. At least it's not something worse, right?
Take care!
Curt B. Shumaker
Take care!
Curt B. Shumaker
#9
Originally posted by shumax
You can also use a bicycle tire pump and shoot air down into the plug wire's hole. At the very worst you might have to buy new wires. At least it's not something worse, right?
Take care!
Curt B. Shumaker
You can also use a bicycle tire pump and shoot air down into the plug wire's hole. At the very worst you might have to buy new wires. At least it's not something worse, right?
Take care!
Curt B. Shumaker
Thread
Thread Starter
Forum
Replies
Last Post
monster808
1st gen/323/GLC Engine and Drivetrain
13
September-28th-2004 11:54 PM
PLaSMaN
1st gen/323/GLC Engine and Drivetrain
12
February-25th-2003 01:29 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)