ebay cold air intake for 1.6
#3
looks like a good deal...may need to make a gasket for the maf...doesnt seal to metal that well....but it definitely looks worth it...you'll get a little better look with the injen,but not much and probably the same performance, so is the extra $200 worth it to you??
#4
i was wondering about the seal on the maf do you think if you put a small beed of silicon would work that would make it air tight? also will the intake **** up my engine i had a custom intake on it and the seal around the maf was bad so after five months it screwed up the maf sensor and my engine ran like crap. Luckily i still had a warranty and mazda repalced the maf for free and now my car runs like new but i figure a real intake might not screw about any insight would be helpful.
Thread
Thread Starter
Forum
Replies
Last Post
braindamage19
3rd Gen Protege/MazdaSpeed/P5/MP3
8
June-19th-2005 06:23 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)