I installed my aluminum floor plates over the weekend. I think they came out looking OK.

The pedal kit is by Razo, and the wadded up napkins in the cupholder are from Starbucks.

 

Looks pretty cool, probably easier to vaccum too!!

 

can stuff get under them??? I would be worried about stuff getting under them and getting ground into the carpet.

 

Very nice. Where and how much? Also does the metal go far enough so that your heel is still on the metal b/c my carpet is gettin very worn down in the area near the pedal. Thanks.

 

I think they look very nice. How much did they set you back ??

 

Stuff could get underneath, but I will be overlaying plastic mats in the slushy winter months to prevent liquids from getting under there.

Sometimes my clutch foot catches the leading edge of the plate, but I think I can just push the carpet forward to cure that.

I got them from http://www.ompusa.com/pedals.htm, $40 each. One shipped right away, but the other was on backorder for like nine months. I'm not kidding. I guess that's kind of steep, but I really liked the particular pattern on these.

I found some two-part fasteners that have a flathead screw on one side that threads into a short barrel with its own head on the other side. Then I just drilled through the floormats and fastened the metal plates down. It was simple, and if I want to take them out again, the holes in the floormats are practically invisible.

 

i myself cut and bent my own diamond billeted floorboards for my pro5 last year. and yea stuff gets under them but it has definatly made it easier to clean the front and back of my car. Ill post pictures

http://www.cardomain.com/member_page...=210695&page=4