3G Protege: Spark Plug Wires
October-28th-2003 | 10:31 AM
#1
Thread Starter
got zoomed!
Joined: Apr 2003
Posts: 126
From: Calgary
3G Protege: Spark Plug Wires
Last edited by ZoomZm; April-18th-2011 at 10:37 AM.
October-28th-2003 | 01:17 PM
#2
Registered User
Joined: Aug 2002
Posts: 349
From: New Jersey
Re: HOW TO install wire
It's an easy job. Remove the old wires by grasping the boot and then gently pulling the terminal off the contact. When installing the new wires make sure that you use Dielectric Tune-up Grease such as the type made by Permatex.
From the Permatex instructions: Remove any old grease wth a clean cloth. Coat inside of spark plug boot and ceramic portion of spark plug with a thin layer of Dielectric Grease. Also coat inside of boot attaching to coil pack. The reason for using the grease is to prevent tearing and damage should you have to remove the new wire set for any reason.
From the Permatex instructions: Remove any old grease wth a clean cloth. Coat inside of spark plug boot and ceramic portion of spark plug with a thin layer of Dielectric Grease. Also coat inside of boot attaching to coil pack. The reason for using the grease is to prevent tearing and damage should you have to remove the new wire set for any reason.
Thread
Thread Starter
Forum
Replies
Last Post
ZoomZoomBlue
3rd Gen Protege/MazdaSpeed/P5/MP3
0
January-20th-2004 10:59 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)