Haltech's and BPT's
#1
Haltech's and BPT's
Anyone interested in more deals?? I just ran into a great deal on haltech E6K kits!
Heres the scoop:
Haltech E6K (Single Buyer) $1175
Haltech E6K (3 Buyers) $1125
Haltech E6K (10 Buyers) $1075
(Includes TPS, Water Temp, Air Temp, Flying Harness)
This is enough to run a N/A motor, note that it does not come with a MAP Sensor.
The options that you have are these:
1Bar Map sensor (Used for N/A Cars not wanting use of TPS sensing) +$65
3Bar Map Sensor (Up to 30psi of boost) +$120
Flying Harness Connector Kit (GM Weatherproof Connectors) +$90
Fully Terminated Harness (Wrapped, Shielded, Plug n Play) +$125
Boost Control Solenoid $80
Trim **** Module (boost/fuel/ignition) $75
Also if you'd like to purchase a GTX Motor at the same time I can work even better deals into it!
GTX Motor Alone $750
GTX Motor w/ Haltech & 3BAR $2000
:begin cheesy advertisement: Get em while their hot! Summer is here, time to make your car faster. I know the wife wanted that pretty diamond bracelet, but grab a beer and work on the car =) :end cheesy advertisement:
Heres the scoop:
Haltech E6K (Single Buyer) $1175
Haltech E6K (3 Buyers) $1125
Haltech E6K (10 Buyers) $1075
(Includes TPS, Water Temp, Air Temp, Flying Harness)
This is enough to run a N/A motor, note that it does not come with a MAP Sensor.
The options that you have are these:
1Bar Map sensor (Used for N/A Cars not wanting use of TPS sensing) +$65
3Bar Map Sensor (Up to 30psi of boost) +$120
Flying Harness Connector Kit (GM Weatherproof Connectors) +$90
Fully Terminated Harness (Wrapped, Shielded, Plug n Play) +$125
Boost Control Solenoid $80
Trim **** Module (boost/fuel/ignition) $75
Also if you'd like to purchase a GTX Motor at the same time I can work even better deals into it!
GTX Motor Alone $750
GTX Motor w/ Haltech & 3BAR $2000
:begin cheesy advertisement: Get em while their hot! Summer is here, time to make your car faster. I know the wife wanted that pretty diamond bracelet, but grab a beer and work on the car =) :end cheesy advertisement:
#2
Braden
Have you got your 10 yet? i saw you had a lot of interest on the EGT board....
I'm local....how much would you charge for the install to get it up and running??
Also ....any problems with CA emmisions???
I'm local....how much would you charge for the install to get it up and running??
Also ....any problems with CA emmisions???
Thread
Thread Starter
Forum
Replies
Last Post
turboge
1st gen/323/GLC Engine and Drivetrain
2
November-7th-2002 04:14 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)